02.2010
5
Safety Instructions
The dispenser may not be subject to frost duri-
ng operation, storage and transport:
- In order to prevent damage due to frost, the
service technician must completely drain the
water from the boiler prior to storage and
transport and must also remove any residual
water from hoses and valves.
- It is recommended to store and transport the
dispenser in its original packaging.
- However, if there is the danger of damage
due to frost, the service technician must
check and replace boiler, hoses and valves if
required prior to reconnecting the dispenser
and he should additionally carry out a
functional test.
Health notes
Never touch the power supply plug
with wet hands or plug it in if the plug
itself is wet.
The liquids delivered by the dispenser
are hot!
In order to prevent scalds, keep your
hands and other body parts out of the
delivery area during dispension.
This dispenser is not intended to be
used by persons (including children)
with limited physical, sensory or men-
tal faculties or by persons with insuf-
cient experience and/or insufcient
knowledge unless these persons are
supervised by a person responsible for
their safety or have received instruc-
tions from that person on how to use
the dispenser.
Children should be supervised to
ensure that they do not play with the
dispenser.
•
SAFETY INSTRUCTIONS
General notes
Before putting the dispenser into operation, the
operator manual must be carefully read and
fully understood.
Only authorised and qualied personnel may
clean, ll up and set the dispenser via the touch
screen.
The dispenser may only be installed,
programmed and repaired by specially trained
service technicians who are familiar with the
safety and hygiene aspects of the dispenser.
Use only original spare parts.
The dispenser may not be installed outside.
The dispenser must be placed where it can be
looked after by trained personnel.
The dispenser may not be cleaned
under a water jet and is not suitable for
installation on surfaces next to which
water jets are being used (e.g. for
cleaning).
If the dispenser is not to be used for a shorter
period of time (e.g. over the weekend), use the
ON/STANDBY/CLEAR switch to activate the
STANDBY mode.
As a result, the power supply is not completely
interrupted. The product packs continue to be
sufciently cooled in the ingredient storage unit.
If the dispenser is not used for a very long time
period (e.g. during works holidays), unplug
the mains plug, close the water tap, remove
the product packs (BIB) and store them in a
refrigerator depending on the 'best before date'.
•
•
•
•
•
•
•
•
(48 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals